Step 4: Setting Up The Ac2 And Ck30S - Intermec CK30 Installation Manual

Intermec ck30: install guide
Hide thumbs Also See for CK30:
Table of Contents

Advertisement

Setting Up the AC2 and CK30s
Note: If you have already unpacked and installed the AC2, begin with
Step 5.
Get the AC2 power supply and the AC power cord from the Accessories box.
Place the charging dock on a flat, stable, and clean surface that is within
1.5 m (5 ft) of an AC power outlet.
Connect the power supply to the power connector on the back of the AC2.
Connect the power supply to an AC
power outlet. The yellow Power light
turns on showing that the charging
dock is ready to charge.
Get a CK30 and an AB1 battery
from one of the CK30 shipping
boxes.
Insert the tabs on the
bottom of the battery into
the CK30 and snap the
battery into place.
If you want to use the
included AL2 handstraps,
continue with the next step.
If you do not want to install
the handstraps, continue
with Step 8.
24
Power
light
AB1 battery
Get an AL2 handstrap from the Accessories box and follow the instructions in
the shipping bag to install the handstrap on the CK30.
You will need to unhook the bottom of the handstrap to remove and install
the AB1 battery.
Top of
handstrap
Handstrap
hook
Slide the CK30 into any
of the four bays on top of
the charging dock. The
Charge light for that bay
turns on to indicate the
battery charge status.
For more information,
see the AC2 Charging
Dock Quick Start Guide
that shipped with
the dock.
Charge
lights
Repeat Steps 5 through 8 for the other CK30.
Adjustment
tab
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Easycoder pm4iEasyadc

Table of Contents