Intermec CK30 Installation Manual page 19

Installing the PM4i (continued)
Adjust the position of the green edge guide so the media is guided with a
minimum of play and lock the nut.
Adjust the position of the edge guide on the label slack absorber according
to the width of the media.
36
Close the front and side doors, making sure that the media runs through the
front door slot.
Turn on the PM4i. The LCD display on the front of the printer shows
initialization messages. When initialization is complete, the EasyADC
Console looks for the printer and connects it to the network. When the
printer is connected, it pulls the excess ribbon back in and prints a test label.
The red error light turns off, and the blue light stays on, indicating that the
PM4i has been configured correctly. Skip ahead to Step 7, "Setting Security."
If the test label does not print and the red error light stays on, there is a
problem connecting the printer. Continue with Step 28.
Double-click the EasyADC Console icon on the taskbar.
Console icon
37