Charging The Main Battery Pack; Removing And Installing The Main Battery Pack - Intermec Trakker Antares 2400 User Manual

Trakker Antares 242X Handheld Terminal User's Manual
39 AGaramond
nugget

Charging the Main Battery Pack

You need to fully charge the battery pack before you can use the terminal.
To charge the main battery pack
• Place the battery pack in an empty slot in the battery charger. The
battery pack is fully charged in about 2 hours. For help, see the
documentation that came with your battery charger.
• Use the communications dock or the optical link adapter to trickle
charge the battery pack. You must have a power supply connected to the
dock or optical link adapter to charge the battery pack. For help, see the
Trakker Antares TD2400 Communications Dock Quick Reference Guide
(P/N 065555) or the Trakker Antares Optical Link Adapter Quick
Reference Guide (P/N 065826).

Removing and Installing the Main Battery Pack

If the main battery pack charge goes low, you need to replace it or charge
the battery pack as soon as possible.
Removing the battery pack while the terminal is on may cause loss of
data.
Attention: Ne détachez pas le jeu de piles pendant que le lecteur est
actif car cela pourrait entraîner la perte de données.
To remove the battery pack
1 Press q to turn off the terminal.
2 Open the battery door by pushing down on the battery door latch and
sliding it toward the bottom end of the terminal. Lift up the top edge of
the battery door to remove it.
Note: If you have a handstrap installed, stretch the handstrap's elastic
band to allow the T-bar to slide out of the T-bar opening on the bottom
end of the terminal. Move the handstrap out of the way to open the
battery door.
TOP
242XU079.eps
3 Remove the battery pack from the terminal.
Chapter 1— Learning About the Terminal
Battery door
latch
BOTTOM
9