Intermec CK30 Installation Manual page 16

Installing the PM4i (continued)
Remove the wrapper from the ribbon and set the cardboard takeup roll aside.
Slide the ribbon onto the supply hub so the shiny side faces up when the
ribbon is routed through the print mechanism.
Route the ribbon through the print mechanism under the transparent upper
LSS guide. Pull out about 20 cm (8 in) of ribbon leader.
20 cm
(8 in)
30
Without releasing the ribbon, turn the printhead lift lever clockwise to engage
the printhead and lock the ribbon.
Slide the cardboard takeup roll onto the ribbon rewind hub.
31