Intermec CK30 Installation Manual page 18

Installing the PM4i (continued)
Install the high edge guide by reversing Step 17. For help, see "Media Supply
Roll Post" in Chapter 2 of the EasyCoder PM4i Bar Code Label Printer User's
Guide.
Get a roll of 4x6-inch media from the EasyADC shipping box.
Place the roll on the supply post and push it all the way to the bottom of
the post.
34
Fold up the edge guide and slide it next to the edge of the media roll to hold
the roll in place on the supply post.
Route the media through the print mechanism, keeping the media as close to
the middle wall of the printer as possible. The label path shown here is also
illustrated inside the printer lid.
Turn the printhead lever counterclockwise to engage the printhead.
35