Intermec CK30 Installation Manual page 7

Installing the WA22 (continued)
Route the Ethernet cables through the cable routing channels in the bracket.
Mount the WA22 in the bracket by inserting the shoulder screws into the
keyhole slots in the bracket. Slide the WA22 down until it is firmly seated.
Mounting
screws
(2-6 places)
Connect one Ethernet cable to the WA22 Ethernet port.
Ethernet port
12
Cable routing
channels
Mounting
bracket
Connect the Ethernet cable from the WA22 to the Power & Data Out port on
the power bridge.
Connect an Ethernet cable from the Data In port on the power bridge to a
port on an Ethernet hub or switch connected to your LAN.
Connect the AC power cord to the power bridge and an AC outlet.
Data In
Power &
Data Out
To Ethernet
On the WA22, the green Power light turns on and stays solid and the other
lights start blinking as the WA22 boots. The blue light turns on and remains
on after the WA22 has finished booting.
13