JANUS 2010 Hand-Held Computer User's Manual
Installing the NiCad Battery Pack
You must install the newly charged battery pack into the reader.
To install the battery pack
1. Make sure the two yellow battery pack locks on the end of the battery pack
2. Place the two battery pack tabs under the reader's back.
3. Slide the battery pack into the back of the reader until it snaps into place.
4. Push the two battery pack locks up to lock the battery pack in place.
1-8
(4MB)nugg
are pushed down in the unlocked position.
Reader
Note: The battery pack locks must be closed to use the reader.
CODEhel
nuggCODE
Reader
Battery pack
tab (2 places)
2010U.112
Battery
pack lock
(2 places)
Battery
pack