Using The Remote Controller - Integra DTR-5 Instruction Manual

Using the remote controller

Overview
When you use a remote controller, typically you press one of the MODE buttons that corresponds to the device you wish to control, then
press the operation buttons. For example, if you wish to control the DTR-5 from a remote controller, first press the MODE AUDIO button,
then press an appropriate operation button. To control a CD player, press the MODE CD button, then press an appropriate operation button.
First, press the desired MODE button to make sure that the DTR-5 is set to a correct mode.
SEND/LEARN
indicator
POWER ON
MODE AUDIO
POWER ON
SLEEP
MODE
AUDIO
DISPLAY
CH +/–
SP A/B
DIMMER
Using the RC-391M to control each device
Turning the power on and off to the DTR-5
Note:
Before operating the RC-391M, turn on the POWER switch on the
DTR-5 so that the unit enters standby mode.
POWER
1. Press the MODE AUDIO button.
STNBY
2. Pressing the POWER ON buttons will switch power on.
Pressing the POWER STNBY button will power standby.
SEND/LEARN indicator
This indicator acts as a guide when commands are programmed
into or sent by the remote controller. It also warns the user when
an error is made or battery power is low.
Controlling the DTR-5
1. Press the MODE AUDIO button.
2. Press the desired operation button.
Shaded buttons in the figure are the operation buttons used to
control the DTR-5.
SLEEP
POWER ON/STNBY
POWER
STNBY
DISPLAY
VOL q / u
CH +/–
INPUT SELECTOR
Listening mode ( STEREO / DSP √ / DSP ® / SURROUND )
SP A/SP B
CH SEL
VOL
DIMMER
LEVEL +/–
TEST
TEST
MUTING
MUTING
INPUT
SELECTOR
Litening
mode
LEVEL +/–
CH SEL
: Sleep function
: Power on/standby
: Changing the display
: Adjusting the volume
: Tuner preset number increment/decrement
: Changing Listening mode
: Switching between Speakers A and B
: Selecting a speaker
: Adjusting the brightness of the display
: Adjusting the speaker levels
: Test tone
: Muting
31