Integra DTR-5 Instruction Manual page 15

Speaker setup
4
PRESET / MODE ADJ
DOW N UP
5
PRESET / MODE ADJ
DOW N UP
1
SP / SYS
SETUP
ENTER / SCAN
SP / SYS
SETUP
2
ENTER / SCAN
PRESET / MODE ADJ
DOW N UP
3
PRESET / MODE ADJ
DOW N UP
4
PRESET / MODE ADJ
DOW N UP
or
ENTER / SCAN
or
or
ENTER / SCAN
or
f t
ENTER / SCAN
meter feet
f t
f t
ENTER / SCAN
f t
f t
ENTER / SCAN
f t
4. Select the size of the center speaker.
Pressing the PRESET/MODE ADJ √ / ® buttons switches
among "LARGE," "SMALL," and "NONE."
Note:
If you have selected "SMALL" for the front speakers, you can
select only "SMALL" or "NONE" for the center speaker.
LARGE: When a large speaker is used as the center speaker.
SMALL: When a small speaker is used as the center speaker.
NONE: A center speaker is not connected.
Select whichever appropriate and press the ENTER/SCAN but-
ton.
5. Select the size of the surround speakers.
Note:
If you have selected "SMALL" for the front speaker, you can
select only "SMALL" or "NONE" for the surround speakers.
LARGE: When large speakers are used as the surround
speaker.
SMALL: When small speakers are used as the surround
speaker.
NONE: Surround speakers are not connected.
Select whichever appropriate and press the ENTER/SCAN button.
This completes the CONFIG SETUP settings.
Setting the DISTANCE parameters
Set the distance from the listening position to each speaker.
1. Press the buttons in the following sequence to display "DIS-
TANCE SETUP."
2. Set the distance to the front speakers.
Pressing the ENTER/SCAN button while "DISTANCE
SETUP" is displayed will cause the "FRONT" distance parame-
ter to appear.
Press the PRESET/MODE ADJ √ / ® buttons to set the closest
distance value. You can set the distance in the range of 1feet
(0.3m) – 30feet (0.9m) in 1feet (0.3m) steps.
Press the ENTER/SCAN button to confirm the value.
3. Set the distance to the center speaker.
Press the PRESET/MODE ADJ √ / ® buttons to set the closest
distance value.
Press the ENTER/SCAN button to confirm the value.
Note:
If you have selected "NONE" for the center speaker of the
CONFIG parameter, skip this note.
You cannot set a larger value than the front speaker distance.
You cannot set a smaller value than the front speaker distance
deducted by 5feet (1.5m).
4. Set the distance to the surround speakers.
Press the PRESET/MODE ADJ √ / ® buttons to set the closest
distance value and press the ENTER/SCAN button.
Note:
If you have selected "NONE" for the surround speaker of the
CONFIG parameter, skip this note.
You cannot set a larger value than the front speaker distance.
You cannot set a smaller value than the front speaker distance
deducted by 15feet (4.5m).
This completes the DISTANCE settings.
15