Integra DTR-5 Instruction Manual page 19

Selecting a sound source
LEFT CENTER
SUBWOOFER L-SURROUND
1
2
4-1
4-2
RIGHT
R-SURROUND
When Multi channel input is selected as a source
Follow the steps below to adjust the level of each speaker if you
have selected MULTI CH INPUT.
1. Press MODE AUDIO button on the remote controller.
2. Press MLT button on the remote controller.
You cannot select any listening mode.
3. Play the device connected to the MULTI CHANNEL INPUT
jack.
4. Adjust the volume level of each speaker.
4-1. Press the CH SEL button to select the desired speakers.
4-2. Use the LEVEL +/– button to change the volume level of
the speakers.
You can adjust the volume level of each speaker individu-
ally. Adjust the level while listening to the sound in the lis-
tening position.
You can adjust the level of the front, center, and surround
speakers in the range between –12dB and +12dB.
You can adjust the subwoofer level in the range between –
30dB and +12dB.
Note
Adjusting the volume level of each speaker for the MULTI CH
INPUT source does not affect the speaker level adjusted by the
Test Tone function, and vice versa.
If the speaker level is set to +1dB or higher, the maximum level
indicated on the display will change if you raise the volume
level. Refer to "About volume (VOLUME)" on page 20 for
more information.
19