Video Equipment Connections - Integra DTR-5 Instruction Manual

Video equipment connections

On each pair of input jacks, a red connector (marked R) corresponds to the right
channel, and a white connector (marked L) to the left channel.
A yellow connector (marked V) is used for video connection.
Please refer to the instruction manual of each component when making any con-
nections.
AUDIO OUTPUT
VIDEO OUTPUT
RISK OF ELECTRIC SHOCK
ANTENNA
DVD
AM
VIDEO 3
VIDEO 2
FM
75
VIDEO 1
GND
(PLAY)
I N
L TAPE
OUT
(REC)
R
PHONO C D
AUDIO OUT
AUDIO IN
Video Cassette Recorder
Notes:
When using a playback-only VCR, connect it to VIDEO 2 or VIDEO 3. If you connect it to VIDEO 1, you need to make only the out-
put connections.
This receiver can be used with only a monitor TV equipped with a video input jack.
Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart
as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).
A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in
conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT (REC) and
VIDEO 1 OUT will not work.
Remove the protective cap attached to the DIGITAL INPUT (OPTICAL) jack before making the connection. When this jack is not
used, replace the protective cap.
DVD Player
DIGITAL COAXIAL OUTPUT
DIGITAL OPTICAL OUTPUT
WARNING AVIS
RISQUE DE CHOC ELECTRIQUE L
DO NOT OPEN NE PAS OUVRIR
R L V
FRONT
SPEAKERS
I N A
R
I N
I N
CENTER
SPEAKER
I N
FRONT
OUT
R L
SURROUND
MONITOR
V
OUT
R L
SUBWOOFER
SUB
PRE OUT
CENTER
WOOFER
R L MULT I CHANNEL I NPUT
VIDEO IN
VIDEO OUT
Digital audio connections
This receiver has a powerful digital signal
processor for use with DVD players, DAT
decks, and CD players. The digital inputs,
COAXIAL 1, 2 and OPTICAL can be
assigned to individual input selector buttons,
so when an input selector button is pressed, the
assigned digital input is used instead of the
corresponding analog input. (See page 18.)
L
L L
FRONT
SPEAKERS
B
R
R R
L L
SURROUND
SPEAKERS
R R
CAUTION: SPEAKER IMPEDANCE
6 OHMS MIN. PER EACH
SPEAKER TERMINAL
AV RECEIVER
DTR-5
MODEL NO.
RATING:
AC120V 60Hz 3.9A
2-1, NISSHIN-CHO, NEYAGAWA-SHI,OSAKA,
JAPAN MANUFACTURED IN MALAYSIA
VIDEO IN
VIDEO OUT
Monitor TV
Audio connection cable
L (Left)
R (Right)
Video connection cable
V (Video)
DIGITAL INPUT
COAXIAL 2
COAXIAL 1
AC I NLET
OPTICAL
REMOTE CONTROL
AC 120V 60Hz
SWITCHED
TOTAL 120W 1A MAX.
: signal flow
AUDIO OUT
VDP Player
L
R
V
7