Tuning In A Radio Station - Integra DTR-5 Instruction Manual

Tuning in a radio station

1
FM AM
2
DOWN TUNING UP
24
DIMMER
STANDBY/ON
STANDBY
POWER
ON OFF
A SPEAKERS B
DISPLAY
PHONES
MULTI CH DVD
INPUT
DISPLAY
FM MUTE /
MODE
DISPLAY
FM MUTE/MODE
TUNING DOWN/UP
MASTER VOLUME
FM MUTE / DIGITAL/ SP / SYS
MODE ANALOG SETUP CH LEVEL
MEMORY DOWN TUNING UP
MODE
PRESET / MODE ADJ
DOW N UP
ENTER / SCAN
LISTENING MODE
LATE NIGHT / LFE LEVEL
STEREO /DTS SURROUND 5 CH STEREO DSP FRONT EFFECT Re -EQ CONTROL
BASS
VIDEO 1 VIDEO 2 VIDEO 3 TAPE FM AM PHONO C D
FM
AM
Manual tuning
1. Press the FM or AM button.
2. Use the TUNING UP/DOWN buttons to change the fre-
quency.
UP.....................the frequency increases.
DOWN..............the frequency decreases.
The frequency changes in 50 kHz steps in FM and 10 kHz in
AM each time you press the TUNING UP/DOWN button.
In FM, if this button is held continuously for more than 0.5 sec-
onds, the frequencies are scanned automatically (FM auto tun-
ing mode). When a broadcast is received, scanning stops.
ch
Listening to a stereo radio station (FM mode)
When you tune in a stereo FM station, the FM STEREO indicator
lights up if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune in to the desired
station. In this case, tune in as follows.
Press the FM MUTE/MODE button. The FM MUTE indicator
turns off. At this time, the station will be in mono and interstation
noise will be heard. Select the station to which you want to listen.
DISPLAY button
Pressing the DISPLAY button each time will change the indication
as follows:
Frequency (preset No.)
TREBLE
Listening mode