I Id-Rp2D (Front Panel); I Id-Rp2D (Rear Panel) - Icom ID-RP2 Instruction Manual

I ID-RP2D
(Front panel)
q POWER SWITCH [POWER]
The power switch for ID-RP2D.
The LED indicator located at right lights when the
power is turned ON.
w HIGH/LOW POWER SELECT SWITCH [H/L]
Selects the transmit output power High
and Low
10 W) (approx. 1 W)
I ID-RP2D
(Rear panel)
q ANTENNA CONNECTOR [ANT] (p. 11)
Connect the optional AH-108 1.2 GHz Collinear an-
tenna.
When both ID-RP2D and ID-RP2V is composed in
a site, an antenna filter, such as bandpass filter, res-
onator, or so, should be installed between the ID-
RP2D and antenna to protect the ID-RP2D recep-
tion from interference of the ID-RP2V downlink
signal.
w COOLING FAN
q w e
(approx.
.
e SERVICE CONNECTOR [SERVICE] (p. 41)
Connects a PC via an USB cable
separately)
quencies.
q
e POWER CONNECTOR [DC13.8V] (p. 11)
Connects to ID-RP2C via the supplied DC power
cable
(OPC-1309)
r [CONT I/O] (p. 11)
Connects to ID-RP2C via the supplied control cable
for received or transmitted serial data communica-
tion.
t GROUND TERMINAL [GND] (p. 10)
Connects to a ground to prevent electrical shocks,
TVI, BCI and other problems.
6
PANEL DESCRIPTIONS
to set the both transmit and receive fre-
w e r t
to be supplied the DC power.
3
(A-B type; purchase