Icom ID-RP2 Instruction Manual page 43

!0 Unit initial
Enter the local repeater initial
each connected local repeater to [LOCAL RPT—
CONT I/O] connector.
This initial is an identical initial for each unit, and fol-
lows the call sign.
e.g.: The "C" is the initial of JA3YUA_C.
Usable characters are A to D
IMPORTANT!
The initial "A" must be applied to both the ID-
RP2D and ID-RP2V, and NEVER duplicate the
initial within the data and the voice repeaters.
Otherwise the communications between local re-
peaters won't function properly.
!1 Use Local Server
(local server usage)
Turn the local server (e-mail, WEB server, etc.) con-
nection availability to the ID-RP2C ON and OFF.
Remove the check mark (✔) when no local server is
connected.
Un-connectable command is automatically replied
when the packet to the local server is received with-
out the check mark (✔) setting.
NOTE: Gateway connection is excluded with this
setting.
Therefore, remove the check mark (✔) when no
local server is connected even when connecting
a gateway server.
!2 Use Gateway (gateway usage)
Selects the gateway connection capability with this
local repeater ON and OFF.
Apply the check mark (✔) when persists the gate-
way connection, however, remove the check mark
(✔) when inhibit the gateway connection.
Un-connectable command is automatically replied
when the packet through a gateway is received
without the check mark (✔) setting.
!3 IP Address
Enter the IP address of the connectable gateway.
for
(one character)
.
(capital letters only)
!4 Port (port number)
Enter the UDP port number of the connectable
gateway.
!5 IP Address
Enter the local IP address of the repeater.
!6 Port (port number)
Enter the UDP port number of the repeater.
Use the default setting normally.
!7 Subnet Mask
Enter the subnet mask of the network if the repeater
is connected to the existing network
Set the same subnet mask of the PC for repeater
setting and server
connected.
!8 Def. Gateway
(Default gateway)
Set the default gateway address of the network that
to be connected to, if connecting to another network
through the repeater.
And, set the same default gateway address of the
local server, if the local server has a different net-
work setting from the repeater network setting.
!9 Use Assist 1/2
(Assist repeater 1/2 usage)
This setting is for microwave link repeaters.
(1) and (2) connectors for the microwave link re-
peaters are available.
Apply the check mark (✔) into the corresponding
initial's check box to activate the microwave link re-
peater.
@0 Always TX
(Continuous transmission)
Apply the check mark (✔) when continuous test
transmission is required, such as when the mi-
crowave link repeater installation, parabolic antenna
adjustment.
Remove the check mark (✔) in regular operation.
40
REPEATER SETTINGS
(Default: 172.16.0.1)
(Default: 20319)
(e.g., LAN)
(gateway or local server, etc.)
7
.
, if