Connections And Installations; I Precautions; D About Coaxial Cable; I About The Power Supply - Icom ID-RP2 Instruction Manual

4

CONNECTIONS AND INSTALLATIONS

I Precautions

R DANGER!
ID-RP2 installation, particularly ID-
RP2L and antennas, is intended for professional in-
stallation only. We are not responsible for any
building breakage, any damage resulting from a drop
of the ID-RP2L or antenna from a high place or un-
stable site or resulting from any personal injury nor
any accident in any other cases. Be sure to consult
an expert engineer for installations.
D D About coaxial cable
• Type-N connector assembling
Nut Rubber gasket
q
15 mm
Washer
w
Center
Clamp
conductor
3 mm
6 mm
e
Solder hole
No space
r
Be sure the center conductor is
the same height as the plug body.

I About the power supply

Slide the nut, washer,
rubber gasket and clamp
over the coaxial cable,
then cut the end of the
cable evenly.
Strip the cable and fold the
braid back over the clamp.
Soft solder the center
conductor. Install the
center conductor pin and
solder it.
Carefully slide the plug
body into place aligning the
center conductor pin on the
cable. Tighten the nut onto
the plug body.
NEVER expose the ID-RP2C/D/V to rain, snow or any
liquids.
NEVER connect the repeater to a power source using
reverse polarity. This will damage the repeater.
And turn the repeater power OFF when connecting a
power supply.
AVOID using or placing the ID-RP2C/D/V in areas with
temperature below –10˚C (+14˚F) or above +50˚C
(+122˚F).
AVOID placing the ID-RP2C/D/V in excessively dusty
environments or in direct sunlight.
AVOID placing the ID-RP2C/D/V against walls or
putting anything on top of the units. This will obstruct
heat dissipation.
Use 50 Ω of impedance for both antenna
and coaxial cable.
power point)
Type-N connector is used for the connection between
ID-RP2D/V and antenna.
RECOMMENDATION: Install a lightning protector
between the ID-RP2D/V and antenna.
Be sure to the DC power supply that used with the ID-
RP2 system is meet the followings:
Output voltage : 13.8 V DC ±15%
Current capacity : At least the total current consump-
tion of the connected equipments.
9
(at Feeding