Table of Contents
Advertisement
P/N 0501930_G
Align End Frames
n
oTe ThaT alignmenT order is
differenT from TighTening order
r
efer To The illusTraTion
NOTE: cases must be level before joining.
1 . Insert alignment pin at lower front and
lower back .
Alignment Pin
Alignment Pin
2 . Insert the alignment rod (
6 in .) through hole in top rail, align and insert
into second to rail .
3 . Move the second case as close to the first as
possible by pushing or using lever bar (mule).
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
!
.
1
/
in . diameter x
4
Alignment Rod
4 . Match alignment pins with corresponding
holes in foam bottom and canopy .
5 . In both holes in bottom shoe, place a 2
inch neoprene washer between end frame and
metal washer of each merchandiser . Loosely
assemble bolt, washers, lockwasher and nut
as shown on the next page .
DO NOT TIGHTEN FULLY.
Do not attempt to draw merchandisers together
using nut and bolt.
6 . Insert a machine screw (#10 x 1
through each hole in canopy end cap, align
and insert into joining canopy end cap .
Fasten with nuts . See detail below and on
next page .
Do not tighten fully.
Ultra Low Front Rear Load
1
/
in .)
4
Contour Canopy
Alignment Pin
Excel
1-7
Advertisement
Table of Contents
