Table of Contents
Advertisement
Shim standard cases in the middle, and at all other
points under the case along the rail as needed
(depending on case length).
Shimming the cases helps avoid case sag and poor
glass alignment.
2. Set first case, and adjust legs over the highest part of
the floor so that case is level. Prevent damage – case
must be raised under leg or by use of 2x6 or 2x4 leg
brace. Remove side and back leg braces after case is
set.
3. Set second case as close as possible to the first case,
and level case to the first using the instructions in
step one.
4. Apply masking tape 1/8" in from end of case on
inside and outside rear mullion on both cases to be
joined.
5. Apply liberal bead of case joint sealant (butyl) to first
case. Sealant area is shown using a dotted line in
illustration in Step 8. Apply heavy amount to cover
entire shaded area.
DO NOT USE PERMAGUM!
Installation cont'd
It is the contractor's responsibility to install
case(s) according to local construction and
6. Slide second case up to first case snugly. Then level
second case to the first case so glass front, bumper
and top are flush.
Do not use cam locks to pull cases together.
7. To compress butyl at joint, use two Jurgenson wood
clamps. Make sure case is level from front to back
and side to side on inside bulkheads at joint.
8. Attach sections together via the camlocks pictured
in the illustration below.
Optional St. Steel
Slanted Deck Pan
A,C,D,E
D
9. Apply bead of butyl to top of bulkheads and slip on
stainless steel bulkhead cap. Also apply butyl to
seam between overhead light tubes.
10. VERY IMPORTANT! Apply liberal amounts of
black butyl to area under interior lower legs and fill
all voids down to bulkhead.
11.Use finger to smooth butyl as thin as possible at
masking tape on inside and outside of rear mullion
6
health codes.
A,B,D
(Meat/Fish)
A,B,D
A,C,D,E
C,E
LEGEND
A = Straight Case
B = Inside Wedges
C = 45 ° Wedges
D = 30 ° Outside Wedges
E = 90 ° Outside Wedges
IGSV-ESC-0303
A,B
B
A,C,D,E
Advertisement
Table of Contents
