Hussmann ESC Installation And Operation Manual page 21

Rev. 0303
6. VERTICAL AND FRONT TO BACK ADJUSTMENT
AND OPENING OVERLAP PROBLEMS
• V A
ERTICAL DJUSTMENT
1. Remove 2. Lift open
top glass glass panel(s)
and panel and relieve
enclosing tension on
mini-top hinge.
hardware.
• F B A
RONT– ACK DJUSTMENT
1. Remove 2. Estimate
top glass amount of
and panel adjustment
enclosing and make
mini-top pencil mark
hardware. on the
NOTE: Standard shim thickness is 1/16"
3. Loosen hex screw 4. Add or remove
(1/4" allen). shims as needed.
Remove chrome (see note on shims
access plate in order below)
to hold nut plate.
Inside
Chrome cap
of Case
for access to
nut plate
3. Lift open 4. Loosen hex screw
glass panel(s) (1/4" allen) slightly.
and relieve Remove chrome
tension on access plate in order
hinge. to hold nut plate.
5. Close glass panel(s)
and check alignment
Retighten hex screw
and reinstall removed
components.
nut
Back
plate
of Case
CUT VIEW:
Mini Top
Hardware
5. Slide the mini-top
forward or backward
to the mark in step 2.
Check alignment of
glass.
Retighten components.
21