Joining Instructions - Hussmann IMPACT Elite ES1 Installation And Operation Manual

1-6 I
NSTALLATION
Check the following to improve opening or
closing of the case front glass.
1. Has the case been leveled according to the
installation instructions. If not, level the case.
2. Is the glass handle installed correctly?
Verify the glass is bottomed out in the handle.
The handle should not be bowed along its
length. Bowing is an indication the handle is not
properly installed.
If the handle is not positioned correctly, it must
be removed. The handle is held in place with
silicone. Remove the handle by pulling it away
from the glass. Do not use tools to pry handle
from glass. Old silicone must be cleaned off the
handle and glass. Apply new silicone into the
handle and firmly press handle onto the glass.
P/N 0453549

JOINING INSTRUCTIONS

Sectional construction means that two or more
merchandisers may be joined in line yielding
one long continuous display requiring only one
pair of ends.
A
LL JOINTS MUST BE AIR
FORMATION OF ICE OR CONDENSATION
Prep Case
1. Check to be sure that merchandisers are
level and that the factory-installed nut
retainers and alignment pins are in place.
Locate Joining Kit and check contents
against parts list.
2. Remove shelves (if installed), display racks,
pans, front shelf supports and front air
grilles from the right end.
Apply Front
Silicone Gasket
Pad
1. Apply a
continuous
bead of
silicone
around the
front joining
hole.
2. Remove paper
backing from
gasket pad
and position
the pad as shown.
-
TIGHT TO PREVENT
.
1.
Apply silicone
2.
Add
Gasket Pad