Joining Instructions - Hussmann Elite Series Installation & Operation Manual

1-8 I
nstallatIon

JOINING INSTRUCTIONS

Sectional construction means that two or
more merchandisers may be joined in line
yielding one long continuous display requir-
ing only one pair of ends .
A
ll joints must be Air
formAtion of ice or condensAtion
Prep Case
1 . Check to be sure that merchandisers are
level and that the factory-installed nut
retainers and alignment pins are in place .
Locate Joining Kit and check contents
against parts list .
2 . Remove shelves (if installed), display
racks, pans, front shelf supports and
front air grilles from the right end .
Apply Front Silicone Gasket Pad
1 . Apply a
continuous
bead of sili-
cone around
the front join-
ing hole .
2 . Remove
paper back-
ing from
gasket pad
and position
the pad as
shown .
P/N 0453549_M
-
tight to prevent
.
1.
Apply
Silicone
2.
Add
Gasket Pad
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
A wedge is not to be joined to another wedge.
Wedges are designed for proper operation
when joined to a parent case.