Replacing Glass Hand Grip - Hussmann IMPACT Elite ES1 Installation And Operation Manual

P/N 0453549
Disassembling Cylinders (refer to illustration)
1. Push out the gas spring pin – A – with the
aid of a graver – B – and small hammer (6 oz
[150 gram]).
2. The E-ring – C – comes out of its seat.
3. Complete the extraction of the gas spring pin
– A.
A
C
Assembling Cylinders (refer to illustration)
1. Insert the gas spring – D – into the case.
Hold the hinge in the 'open' position.
2. Insert the gas spring pin – A – into the hole
of the hinge and into the gas spring – D.
3. Insert the E-ring – C – to properly seat the
gas spring pin – A – utilizing tool – E
A
C
E
Hussmann Corporation • Bridgeton, MO 63044-2483 U.S.A.
B
D
WARNING
!
Once cylinders are removed,
front glass will have NO support
to maintain it in a raised position.
Support the front glass at all times
until cylinder is replaced
or the glass is lowered.

REPLACING GLASS HAND GRIP

The hand grip is fastened to the curved glass as
shown below. A 2 inch (51 mm) bead of silicone
needs to be placed 3 inches (76 mm) from each
end and in the center of the hand grip. The duct
tape is placed on the glass to provide a tight fit.
Duct Tape
Glass
3
/ in. (10 mm)
8
3 in.
(76 mm)
CAUTION
!
Cylinder rods must point down so
oil will lubricate the rod and seals. Failure to
lubricate will severely shorten cylinder life.
Elite Service Merchandisers
6-5
3
/ in. (10 mm) of
8
Duct Tape on Each
Side of Bottom
Edge of Glass
Start 2 in. (51 mm)
Silicone Bead
3 in. (76 mm)
From Each End
Glass Grip