Merchandiser Electrical Data; Electrical Connections; Field Wiring; Identification Of Wiring - Hussmann IMPACT Elite ES1 Installation And Operation Manual

2-4 R
EFRIGERATION

MERCHANDISER ELECTRICAL DATA

Merchandiser data sheets are shipped with this
manual. The data sheets provide case electrical
data, electrical schematics, parts lists and
performance data. Refer to the merchandiser data
sheets and case serial plate for electrical
information.

ELECTRICAL CONNECTIONS

All wiring must be in compliance with NEC and
local codes. All electrical connections are to be
made in the electrical raceway or Handy Box.
Leads for all electrical circuits are identified by a colored plastic band:
neutral wire for each circuit has either White insulation or a White
plastic sleeve in addition to the color band.
P ............R
INK EFRIG
L B .R
IGHT LUE EFRIG
D B .D
ARK LUE EFROST
P .......C
URPLE ONDENSATE
B ........F
ROWN AN
G * .......G
REEN ROUND
ELECTRICIAN NOTE: Use copper conductor wire only.
P/N 0453549
/ E
LECTRICAL
WIRING COLOR CODE
. T L
HERMOSTAT OW
. T N
HERMOSTAT ORM
T . T
ERM HERMOSTAT
H
EATERS
M
OTORS
*E
ITHER COLORED
CASE MUST BE GROUNDED

FIELD WIRING

Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified. Field
wiring from the refrigeration control panel to the
merchandisers is required for defrost termination
thermostats and for optional refrigeration
thermostats. When multiple merchandisers are on
the same defrost circuit, the defrost termination
thermostats are wired in series.
THE SERIAL PLATE FOR COMPONENT AMPERES

IDENTIFICATION OF WIRING

Leads for all electrical circuits are identified by
colored plastic bands. These bands correspond to
the color code sticker (shown below) located
inside the merchandiser's raceway.
T . O
EMP RANGE OR
T . T .........L
EMP AN
M
AROON
Y
ELLOW
R
ED
S O C
LEEVE R
ALWAYS CHECK
IGHTS
..R
ECEPTACLES
...D H
EFROST EATERS
........D H
EFROST EATERS
I
OLORED NSULATION
.
120V
208V