Removing Polycarbonate Rail Lamp Cover; Electrical Service Receptacles; Replacing Fluorescent Lamps; Replacing Lamp Holders And End Caps - Hussmann IMPACT Elite ES1 Installation And Operation Manual

P/N 0453549
REMOVING POLYCARBONATE
RAIL LAMP COVERS
The rail covers are removed without tools. From
the front of the case, grasp the cover with both
hands. Apply pressure as shown in the photo.
Pull forward and up as shown in the photo until
the back of the cover clears the retainer.
Reinstall in reverse order.

ELECTRICAL SERVICE RECEPTACLES

The receptacles located on the exterior back of
the merchandisers are intended for scales and
other light duty appliances that are found in meat
and delicatessen departments. The receptacles are
not intended for large motors.
Hussmann Corporation • Bridgeton, MO 63044-2483 U.S.A.
Scale Stand Receptacle

REPLACING FLUORESCENT LAMPS

Fluorescent lamps are furnished with moisture
resistant lamp holders and end caps. Lamps on
lighted shelves have plastic shields. Whenever a
fluorescent lamp is replaced, be certain to re-
install the plastic shields and end caps.
Plastic Shield
Fluorescent
Lamp
REPLACING LAMP HOLDERS AND
END CAPS
The Hussmann Impact lamp holder is designed
to snap into the sheet metal of the case. The
lamp holder has a locking 'nub' which fits inside
the groove of specially designed end caps.
Hussmann
Impact
Lamp Holder
Hussmann
Impact
End Cap
IMPORTANT!
Always replace lamp holders and end caps with
Hussmann lamp holders and end caps.
Use of non-Hussmann parts may result in poor
electrical contact and short lamp life.
Elite Service Merchandisers
6-3
End Cap
Nub
Groove