Configuring Etherswitch Service Module In Router - Cisco NME-16ES-1G Features Manual

How to Configure the Cisco EtherSwitch Service Module
Configuring the Cisco EtherSwitch Service Module in the Router
This section describes how to perform the initial configuration on the router with a Cisco EtherSwitch
service module installed. This section also describes the initial configuration on the Cisco EtherSwitch
service module itself. Once an IP address has been configured on the Gigabit Ethernet interface on the
router (representing the Cisco EtherSwitch service module), you can open a console session to the
Cisco EtherSwitch service module and configure its Fast Ethernet and Gigabit Ethernet interfaces for
Layer 2 or Layer 3 functionality.
Once the Cisco EtherSwitch service module interface has been configured and you boot up the service
module image, you can switch back and forth between the router and the service module.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
DETAILED STEPS
Command or Action
Step 1
dir flash:
Example:
rommon> dir flash:
Step 2
boot flash: image-name
Example:
rommon> boot flash: c3825-i5-mz.050404
Cisco IOS Release 12.2(25)SEC
36
dir flash:
boot flash: image-name
enable
show running configuration
configure terminal
interface slot/port
ip address ip address/subnet mask
no shutdown
end
service-module interface slot/port session
dir flash:
boot flash: image
enable
show ip interface brief
control+shift+6 x
disconnect
show power inline
Cisco EtherSwitch Service Modules Feature Guide
Purpose
Displays a list of all files and directories in router flash
memory.
Boots the router image that supports the Cisco
EtherSwitch service module.
• Enter no when prompted to enter the initial
configuration dialog and then press Enter.