Cisco NME-16ES-1G Features Manual page 77

Cisco EtherSwitch Service Modules Feature Guide
DETAILED STEPS
Command or Action
Step 1
service-module interface slot/port password-reset
Example:
Router# service-module gigabitethernet1/0
password-reset
Step 2
service-module interface slot/port session
Example:
Router# service-module gigabitethernet1/0 session
Step 3
dir flash:
Example:
rommon> dir flash:
Step 4
load_helper filesystem:/file-url ...
Example:
Switch: load_helper flash: xyz
Step 5
boot
Example:
Switch: boot
Step 6
enable
Example:
Switch: enable
Step 7
configure terminal
Example:
Switch: configure terminal
Step 8
enable secret password
Example:
Switch(config): enable secret 5
$1$LiBw$0Xc1wyT.PXPkuhFwqyhVi0
Troubleshooting the Cisco EtherSwitch Service Module Software
Purpose
Resets the password on the router.
Connects to the service module and opens a service
module session.
• Entering no leaves the current configuration file
intact, so you can rename it.
• Entering yes deletes the configuration file.
Note This configuration can only be done if the
service-module session command is entered
within 50 seconds after entering the
service-module password-reset command.
Displays a list of all files and directories in flash
memory on the service module.
Loads and initializes one or more helper images.
Boots the system.
Enters privileged EXEC mode from the service module
prompt.
Enters global configuration mode.
Changes the password.
The secret password can be from 1 to 25
•
alphanumeric characters.
• It can start with a number.
It is case sensitive.
•
It allows spaces but ignores leading spaces.
•
Cisco IOS Release 12.2(25)SEC
77