Cisco NME-16ES-1G Features Manual page 65

Cisco EtherSwitch Service Modules Feature Guide
Command or Action
Step 8
show run interface fastethernet
switch/slot/port
Example:
Switch# show run interface fastEthernet 1/0/24
Step 9
ping tftpserver
Example:
Switch# ping tftpserver
Step 10
show flash:
Example:
Switch# show flash:
Step 11
copy tftp: flash:
Example:
Switch# copy tftp: flash:
Examples
This section provides the following examples:
•
•
•
•
Sample Output for the show run interface fastethernet Command
The following example shows what appears when you enter the show run interface fastEthernet
command:
Switch# show run interface fa1/0/24
Building configuration...
Current configuration : 87 bytes
!
interface FastEthernet1/0/24
no switchport
ip address 172.16.1.100 255.255.255.0
end
Sample Output for the ping tftpserver Command
The following example shows what appears when you enter the ping tftpserver command:
Switch# ping tftpserver
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.1.100, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/9 ms
Copy the image from the tftp server to the switch flash using standard tftp copy
procedure.
Sample Output for the show run interface fastethernet Command, page 65
Sample Output for the ping tftpserver Command, page 65
Sample Output for the show flash: Command, page 66
Sample Output for the copy tftp: flash: Command, page 66
Upgrading the Cisco EtherSwitch Service Module Software
Purpose
Shows the configuration applied on this interface.
Pings the TFTP server. This command copies an image from
a TFTP server to flash memory.
Displays a list of all files and directories in the Cisco
EtherSwitch service module flash memory.
Copies an image from a TFTP server to flash memory.
Cisco IOS Release 12.2(25)SEC
65