Cisco NME-16ES-1G Features Manual page 46

How to Configure the Cisco EtherSwitch Service Module
Command or Action
Step 4
Enter an enable password, and press Return.
Step 5
Enter a virtual terminal (Telnet) password, and press
Return.
Step 6
Enter yes to configure SNMP.
or
Enter no to configure SNMP later through the CLI or
Network Assistant, and then press Return.
Step 7 Enter the interface name, and press Return.
Step 8 When prompted to configure an IP address for the
Cisco EtherSwitch service module , enter yes.
Step 9 Enter the IP address and subnet mask for the Cisco
EtherSwitch service module, and press Return.
Step 10 When prompted to enable the Cisco EtherSwitch
service module as the cluster command switch , enter
yes or no.
Step 11 Enter 2 and press Return.
Examples
This section provides the following examples:
•
•
•
•
•
Sample Output for Initial Configuration Dialog and Basic Management Initiation
The following example shows what appears when you enter yes to begin the initial configuration dialog
and basic management initiation and press Return:
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Cisco IOS Release 12.2(25)SEC
46
Sample Output for Initial Configuration Dialog and Basic Management Initiation, page 46
Sample Output for Entering an Interface Name, page 47
Sample Output for Assigning the IP Address and Subnet Mask, page 47
Sample Output for Configuring the Cisco EtherSwitch Service Module as a Standalone Service
Module, page 47
Sample Output for Saving the Configuration to NVRAM, page 48
Cisco EtherSwitch Service Modules Feature Guide
Purpose
Sets the password to access privileged EXEC mode.
Sets the Telnet password.
The password can be from 1 to 25 alphanumeric
•
characters, is case sensitive, allows spaces, but ignores
leading spaces.
(Optional) Configures Simple Network Management
Protocol (SNMP).
Provides the interface name of the interface that connects to
the management network.
Always use vlan1 as the interface name.
Note
Confirms that you want to configure the Cisco EtherSwitch
service module IP address and subnet mask.
—
Configures the Cisco EtherSwitch service module.
• Entering no configures it as a standalone service
module. It appears as a cluster candidate service
module in Network Assistant.
Entering yes configures it as the cluster command
•
service module.
Saves the configuration to NVRAM.