Cisco NME-16ES-1G Features Manual page 53

Cisco EtherSwitch Service Modules Feature Guide
Command or Action
Step 4
reload slot stack-member-number
Example:
Switch# reload slot 2
Step 5
show switch
Example:
Switch# show switch
Examples
This section provides the following examples:
•
•
•
Sample Output for the switch renumber Command
The following example shows what appears when you enter the switch current-stack-member-number
renumber new-stack-member-number command:
Switch(config)# switch 6 renumber 7
WARNING:Changing the switch number may result in a configuration change for that switch.
The interface configuration associated with the old switch number will remain as a
provisioned configuration.
Do you want to continue?[confirm]...
If another stack member is already using the member number that you just specified, the stack master
assigns the lowest available number when you reload the stack member.
Note If you change the number of a stack member, and no configuration is associated with the new stack
member number, that stack member loses its current configuration and resets itself to its default
configuration.
Do not use the switch current-stack-member-number renumber new-stack-member-number command on
Caution
a provisioned switch. If you do, the command is rejected.
Sample Output for the reload slot Command
The following example shows what appears when you enter the reload slot command:
Switch(config)# reload slot 6
Proceed with reload? [confirm]y
Sample Output for the switch renumber Command, page 53
Sample Output for the reload slot Command, page 53
Sample Output for the show switch Command, page 54
How to Configure the Cisco EtherSwitch Service Module in a Switch Stack
Purpose
Resets the stack member, and applies the configuration
change.
Displays information about the switch stack and its stack
members.
Cisco IOS Release 12.2(25)SEC
53