Cisco NME-16ES-1G Features Manual page 37

Cisco EtherSwitch Service Modules Feature Guide
Command or Action
Step 3
enable
Example:
Router# enable
Step 4
show running configuration
Example:
Router# show running config interface
gigabitethernet1/0
Step 5
configure terminal
Example:
Router# configure terminal
Step 6
interface slot/port
Example:
Router(config)# interface gigabitethernet1/0
Step 7
ip address ip address/subnet mask
Example:
Router(config-if)# ip address 20.0.0.1
255.255.255.0
Step 8
no shutdown
Example:
Router(config-if)# no shutdown
Step 9
end
Example:
Router(config-if)# end
Step 10
service-module interface slot/port session
Example:
Router# service-module gigabitethernet1/0 session
Step 11
dir flash:
Example:
Switch: dir flash:
Step 12
boot flash: image
Example:
Switch: boot
flash:c3750-ipservices-mz.122-0.0.13.EZ
How to Configure the Cisco EtherSwitch Service Module
Purpose
Enters privileged EXEC mode.
Displays the running configuration of the router, which
should have a Gigabit Ethernet interface representing the
Cisco EtherSwitch service module.
Enters global configuration mode.
Enters interface configuration mode, and specifies an
interface for configuration.
Configures an IP address and subnet mask on this Gigabit
Ethernet interface.
Enables the service module port.
Returns you to privileged EXEC mode.
Connects to and opens a session on the Cisco
EtherSwitch service module.
Displays a list of all files and directories in flash memory
on the service module.
Boots the Cisco EtherSwitch service module image.
Cisco IOS Release 12.2(25)SEC
37