Switch Stack Configuration Scenarios - Cisco NME-16ES-1G Features Manual

Switch Stack Configuration Scenarios

Command or Action
Step 9
exit
Example:
Switch(config): exit
Step 10
copy running-configuration startup-configuration
Example:
Switch: copy running-config startup-config
Step 11
reload
Example:
Switch# reload
Step 12
set
Example:
Switch# set
Example
Sample Output for the set Command
The following example shows what appears when you enter the set command:
Switch: set
BAUD=9600
MAC_ADDR=00:00:00:20:30:80
MANUAL_BOOT=yes
SDM_TEMPLATE_ID=0
SWITCH_NUMBER=2
SWITCH_PRIORITY=1
Switch Stack Configuration Scenarios
Table 4
that at least two Cisco EtherSwitch service modules are connected to each other through their Cisco
StackWise ports.
Cisco IOS Release 12.2(25)SEC
78
provides scenarios of how switch stack features are determined. Most of the scenarios assume
Cisco EtherSwitch Service Modules Feature Guide
Purpose
Returns you to privileged EXEC mode.
Copies the configuration from the running
configuration file to the switch startup configuration
file.
This procedure is likely to leave your Cisco
•
EtherSwitch service module virtual interface in a
shut down state.
• You can see which interface is in this state by
entering the show running-configuration
privileged EXEC command.
To reenable the interface, enter the interface vlan
•
vlan-id global configuration command, and specify
the VLAN ID of the shut down interface. With the
Cisco EtherSwitch service module in interface
configuration mode, enter the no shutdown
command.
Reloads the switch stack.
Lists all environment variables, including the current
baud rate.