Replacing Hand Rail; Replacing Panel Edge Guard - Hussmann FG Installation And Service Manual

P/N 0467434_D

REPLACING HAND RAIL

Beginning at one end, remove the hand rail by
pressing down, ➀ ➀ , and back, ➁ ➁ , to release the
back corner from its retainer (refer to the
following illustration). Work along the back
(inside) until the full length is free. Rotate the
hand rail out to release the front edge.
1
To reinstall, catch the front edge of the hand rail
retainer with the inside front of the hand rail as
shown in the following illustration, ➀ ➀ . Rotate
the hand rail in toward the case and press down,
➁ ➁ , until back of hand rail snaps over back of
retainer.
2
1
Hand Rail Snapped onto Retainer
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
2

REPLACING PANEL EDGE GUARD

Beginning at one end of the edge guard, insert a
thin wide plastic tool (such as a putty knife) to
separate the guard from the panel until a finger
can be inserted to rotate the guard off the panel.
Work the length of the panel.
Insert Tool
To reinstall, hook the curved leg of the edge
guard behind the flange on the lower front
panel. Rotate the edge guard forward to snap
onto the lower front panel. Refer to the follow-
ing illustrations.
Panel
Edge
Guard
Edge Guard Snapped onto Lower Front Panel
Lower
Front
Panel
Panel
Edge
Guard
Hook Edge Guard
Behind Flange,
Rotate Forward
Lower
Front
Panel
Low Temperature
6-9
Excel