P/N 0467434_D
3-5
To install the cove trim to the splashguard:
1. Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be neces-
sary to ensure a secure installation.
Splashguard
2. Apply a good contact cement to the cove trim
Trim
and allow proper drying time according to the
directions supplied with the cement.
Cement
3. Install the trim to the splashguard so that it is
Cove Trim
lying flush with the floor. D
O NOT SEAL THE TRIM
.
TO THE FLOOR
4. If required by local health codes the Cove
Trim may be sealed to the floor, using a silicone
type sealer. Sealant must be removed and
replaced when servicing.
Excel
Low Temperature
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.