I
1-12
NSTALLATION
Seal Merchandisers
1. Remove wire rack, rack supports and interior
panels to apply butyl tape.
Butyl Tape
2. Apply butyl tape across the bottom joint. Be
sure to extend the tape up the back and front of
the case.
Silicone sealer may be applied around joining
bolts on both sides in bottom shoe.
INSTALL SPLASHGUARD BRACKETS
Position splashguard brackets to the merchandiser
and level to the floor. Each bracket has a 1
(38 mm) slot at the rear of the bracket where it
attaches to the merchandiser. Tighten screws to
secure the brackets.
Important: Install splashguard brackets before
installing drip piping.
Splashguard
Bracket
Screws
P/N 0467434_D
1
/
in.
2
Leg
OFFSETTING BUMPER
Offsetting the bumper helps to disguise the joint
locations, giving the lineup a smoother look.
Note: The Excel low
temperature case
BUMPERS ARE
DIRECTIONAL. Look
for an arrow inside the
bumper.
1. Locate starter bumper
shipped with the left-end
kit.
2. Remove factory
installed bumper by
pulling bumper away
from bumper retainer. Be
careful not to lose the
internal joint trim on the
bumper.
Pull
Bumper
Internal
Joint Trim
.
.
WWW
HUSSMANN
COM