Cisco XR 12410 Installation Manual page 117

Chapter 3 Installing the Cisco XR 12410 Router
Use the following procedure as an example to route the network interface cables
through the cable-management system and connect them to the line card.
Route an interface cable across the horizontal cable-management tray, through the
Step 1
cable tray opening to connect it to the line card:
•
•
Install a plastic bend-radius clip on the strain-relief ferrule on the connector (see
Step 2
blow-out in
Note
Insert the cable connector into its assigned port.
Step 3
Route the cable up the cable-management bracket and carefully press the cable
Step 4
into the channel so it is held in place by the cable clips
Repeat Steps 3 through 5 for each additional cable connection to that line card.
Step 5
OL-17441-01
For legacy fiber-optic line cards, go to
For current fiber-optic line cards, go to
Figure 3-26).
The bag of bend-radius clips (Part Number 800-06119-01) in the
accessories box that shipped with your router contains two sizes of
bend-radius clips. The clip size is determined by the diameter of the
strain-relief ferrule on the cable connectors. Use the size that provides the
most secure fit on the strain-relief ferrule on the cable connectors in use
at your site.
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
Connecting Line Card Network Interface Cables
Step 2.
Step 6.
(Figure 3-26b).
3-35