Installing The N3240 In The Rack - IBM N3240 Installation And Setup Instructions

Figure 6. Installing the tie-down plate
6. Repeat steps 2 through 5 for the left-hand rail.
7. Repeat steps 1 through 6 for each additional N3240 that you are installing in the rack, making sure to
allow 4U of space for each N3240.

Installing the N3240 in the rack

Use these instructions to install the N3240 in the rack.
32-55 kg (70.5-121.2 lbs)
1. Remove the N3240 front bezel.
2. From the front of the rack, place the N3240 onto the rails and slide it in until the front mounting
bracket of the unit is flush with the frame rails of the rack.
3. At the front of the rack, using four silver pan head M5 screws in the H5 and H11 holes, secure the
N3240 to the rack by threading the screws through the system unit bracket and the rack frame rail
into the threaded rail nuts. Tighten the screws using a flat-bladed screwdriver.
4. From the rear of the rack, use a silver pan head M5 screw 1 to attach the rear of the chassis to the
tie-down plate on each rail, as shown in Figure 7 on page 5.
4
1
CAUTION:
The weight of N3240 weighs 45.4 kg (100 lbs). Use three people to lift an N3240 into a
rack.