Responding To Error Messages - Dell PowerVault 735N Service Manual

Using the System Setup Program: Dell PowerVault 735N Systems Service Manual
passwords, and erase the existing passwords.
To disable a forgotten supervisor password or setup password, perform the following steps.
NOTICE: See "Protecting Against Electrostatic
1. Open the right-side
2. Refer to "System Board
system board.
3. Remove the jumper plug from the PASSWD jumper.
4. Close the system
The existing passwords are not disabled (erased) until the system boots with the PASSWD jumper plug
removed. However, before you assign a new system and/or setup password, you must install the
jumper plug.
NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the
system disables the new password(s) the next time it boots.
5. Repeat steps 1 through 4.
6. Install the jumper plug on the PASSWD jumper.
7. Replace the system
8. Assign a new system and/or setup password.
To assign a new system password using the System Setup program, see
Password." To assign a new setup password using the System Setup program, see
Password."

Responding to Error Messages

If an error message appears on your monitor screen while the system is booting, make a note of the
message. Then, before entering the System Setup program, refer to
Messages (POST Error
errors.
If you are given an option of pressing either <F1> to continue or <F2> to run the System Setup program,
press the <F2> key.
Back to Contents Page
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/setup.htm[3/15/2013 4:18:21 PM]
system cover.
Jumpers" for the location of the password jumper (labeled "PASSWD") on the
doors and then reconnect the system to an electrical outlet and turn it on.
doors.
Messages)" for an explanation of the message and suggestions for correcting any
Discharge."
"System Beep
"Assigning a System
"Assigning a Setup
Codes" and "System