Dell PowerVault 735N Service Manual page 36

Codes and Error Messages: Dell PowerVault 735N Systems Service Manual
Memory double
word logic
failure at
address, read
value expecting
value
Memory odd/even
logic failure
at address,
read value
expecting value
Memory
write/read
failure at
address, read
value expecting
value
Memory
allocation
error
Memory parity
interrupt at
address
Memory tests
terminated by
keystroke
No boot device
available
No boot sector
on hard-disk
drive
No timer tick
interrupt
Non-system disk
or disk error
Not a boot
diskette
Processor or
terminator card
not installed!
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/beep.htm[3/15/2013 4:18:15 PM]
Faulty application
Improperly seated or faulty
DIMMs
POST memory test terminated
by pressing the spacebar
Faulty diskette, diskette/tape
drive subsystem, hard-disk
drive, hard-disk drive
subsystem, or no boot disk in
drive A
Incorrect configuration settings
in System Setup program, or
no operating system on hard-
disk drive
Defective system board
Faulty diskette, diskette/tape
drive subsystem, or hard-disk
drive subsystem
No operating system on
diskette
No microprocessor or
terminator card installed in
secondary microprocessor
Restart the application.
Remove and reseat the
persists, replace the DIMMs.
No action is required.
If booting from a diskette, ensure the diskette is
bootable. If booting from a hard-disk drive, replace
the hard-disk drive. If the problem persists,
replace the system board.
Verify the hard-disk drive
information is correct. Install an operating system
on the hard-disk drive.
Replace the system board.
Ensure the diskette is a bootable diskette. If
booting from a hard-disk drive, ensure the hard-
disk drive is formatted and contains an operating
system. Replace the system
Use a bootable diskette.
Install a terminator card or microprocessor in the
secondary microprocessor connector. See
"Microprocessors" for instructions.
DIMMs. If the problem
System Setup
board.