Dell PowerVault 735N Service Manual page 37

Hide thumbs Also See for PowerVault 735N:
Table of Contents

Advertisement

Codes and Error Messages: Dell PowerVault 735N Systems Service Manual
Read fault
Requested sector
not found
Reset failed
ROM bad checksum
= address
Sector not
found
Seek error
Seek operation
failed
Shutdown failure Defective system board
System backplane
cable error
System backplane
error
Time-of-day
clock stopped
Time-of-day not
set - please
run SETUP
program
Timer chip
counter 2
failed
Unexpected
interrupt in
protected mode
Unsupported CPU
detected in
SLOT n
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/beep.htm[3/15/2013 4:18:15 PM]
connector
Faulty diskette, diskette/tape
drive subsystem, or hard-disk
drive subsystem (defective
system board)
Improperly connected
diskette/tape drive, hard-disk
drive, or power cable
Expansion card improperly
installed or faulty
Defective sectors on diskette
or hard-disk drive
Defective sectors on diskette
or hard-disk drive
Faulty diskette or hard-disk
drive
Improperly attached interface
cables
Improperly attached or missing
backplane
Defective battery or faulty chip
(defective system board)
Incorrect Time or Date
settings or defective system
battery
Defective system board
Improperly seated DIMMs or
faulty keyboard/mouse
controller chip (defective
system board)
Microprocessor not supported
by system
Replace the diskette or hard-disk drive. If the
problem persists,
replace the system
Check that the diskette drive/CD-ROM drive unit
is properly against the interposer board on the
peripheral cage. See "Drives." Replace the
diskette/tape drive interface cable. Reinstall the
hard-disk drive. Check the interface cable and
power cable connections to the backplane board.
See "Drives."
Reinstall the
expansion
persists, replace the expansion card.
Replace the diskette or hard-disk
Replace the diskette or hard-disk
Replace the diskette or hard-disk
Replace the system
board.
Check the primary and secondary SCSI interface
cable connections to the
Check the interface cable connections to the
backplane
board.
Replace the system battery. If the problem
persists,
replace the system
Check the Time and Date settings. See
the System Setup
Program" for instructions. If the
problem persists, replace the system battery. If
the problem still persists,
board.
Replace the system
board.
Remove and reseat the
persists,
replace the
DIMMs. If the problem still
persists,
replace the system
Install a correct version of the
the specified microprocessor connector.
board.
cards. If the problem
drive.
drive.
drive.
backplane
board.
board.
"Using
replace the system
DIMMs. If the problem
board.
microprocessor
in

Advertisement

Table of Contents
loading

Table of Contents