Dell PowerVault 735N Service Manual page 35

Codes and Error Messages: Dell PowerVault 735N Systems Service Manual
Hard disk
controller
failure
Invalid
configuration
information -
please run
SETUP program
Invalid CPU
speed detected
Invalid NVRAM
configuration,
resource
reallocated
I/O parity
interrupt at
address
Keyboard
controller
failure
Keyboard failure Keyboard cable connector
Keyboard data
line failure
Keyboard stuck
key failure
Memory address
line failure at
address, read
value expecting
value
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/beep.htm[3/15/2013 4:18:15 PM]
Incorrect configuration settings
in System Setup program,
improperly connected hard-
disk drive, faulty hard-disk
drive controller subsystem
(defective system board), or
loose power cable
Incorrect ISA_CLR jumper
configuration, incorrect
configuration settings in
System Setup program, or
faulty battery
Microprocessor not supported
by system
System detected and
corrected a resource conflict
when system resources were
allocated using the Resource
Configuration Utility
Expansion card improperly
installed or faulty
Defective keyboard/mouse
controller (defective system
board)
loose or improperly connected,
defective keyboard, or
defective keyboard/mouse
controller (defective system
board)
Keyboard cable connector
loose or improperly connected,
defective keyboard, or
defective keyboard/mouse
controller (defective system
board)
Faulty or improperly seated
DIMMs or defective system
board
Check the hard-disk drive configuration settings in
the System Setup program. Reinstall the hard-
disk drive. Check the interface cable and power
cable connections to the backplane board.
Remove the plug from the ISA_CLR jumper. See
"Jumpers, Switches, and
instructions. Check the
configuration settings. Replace the battery. See
"Battery."
Install a correct version of the
the specified microprocessor connector.
No action is required.
Reinstall the expansion cards (see
Cards"). If the problem persists, replace the
expansion card.
Replace the system board.
Check the keyboard cable connection. Replace
the keyboard. If the problem persists,
system board.
Check the keyboard cable connection. Replace
the keyboard. If the problem persists,
system board.
Remove and reseat the
persists, replace the DIMMs. If the problem still
persists, replace the system
Connectors" for
System Setup
microprocessor
"Expansion
replace the
replace the
DIMMs. If the problem
board.
in