NEC NEAX 2000 IVS2 Maintenance Manual page 17

C
Assign the number of stations in line
CM42
lockout to give Minor (MN) alarm.
Assign the number of detected faulty
trunks to give Minor (MN) alarm.
[Australia Only]
Assign the number of detected faulty
trunks to give Major (MJ) alarm.
[Australia Only]
END
NOTE 1: Even if the external alarm is set as MN or MJ alarm for system initialized (1st data=01),
no alarm is output in the case of Power ON, Reset key operated, initialization from the
MAT/CAT, and initialization by MP SW3 switch selection.
NOTE 2: The External Alarm Kind for "Number of faulty trunks was more than predetermined
number" is fixed as MN or MJ by CM42>06, 07. When CM42>06, 07 is assigned, the
2nd data of CMEA Y=2 simply means the fault information is to be registered into Fault
Memory. In this case, External Alarm kind cannot be changed.
NOTE 3: The External Alarm Kind for "Number of lockout stations was more than predetermined
number" is fixed as MN. The 2nd data of CMEA Y=2 simply means the fault information
is to be registered into Fault Memory.
In this case, External Alarm Kind cannot be changed.
NOTE 4: The External Alarm Kind for "Number of faulty trunks was less than predetermined
number" is fixed to No Alarm. The 2nd data of CMEA Y=2 simply means that the fault
information is to be registered into Fault Memory. In this case, External Alarm Kind
cannot be changed.
NOTE 5: The External Alarm Kind for "Number of lockout stations was less than predetermined
number" is fixed to No Alarm. The 2nd data of CMEA Y=2 simply means that the fault
information is to be registered into Fault Memory. In this case, External Alarm Kind
cannot be changed.
2
NEAX2000 IVS Maintenance Manual
ND-70926 (E), Issue 3.0
DESCRIPTION
CHAPTER 1 MAINTENANCE SERVICE FEATURES
(1) 01
(2) 01-99: Number of Lockout stations
(1) 06
(2) 01-99: Number of Line Fault trunk
(1) 07
(2) 01-99: Number of Line Fault trunk
Fault Messages
DATA
Page 9