No Traffic Data (Number 11); No Fms Position (Number 12) - Garmin G1000 Line Maintenance Manual

Uncontrolled if Printed
______________________________________________________________________________

4.3.11 No Traffic Data (Number 11)

NOTE
The GTS 800 may be at fault. Take the following steps to resolve the prob-
lem:
1. Perform a SET>ACTV configuration reset on the GTS configuration page.
2. If an error is still present, reload the GTS 800 configuration files.
3. If a problem persists, replace the master configuration module and check the
configuration module harness for faults. Replace if necessary.
NOTE
Option and enablement cards will need to be replaced if the master
configuration module is changed. The G1000 NXi System ID number will
change to a new number when installing a new master config module.
4. Load the correct GTS 800 software.
5. Replace the GTS 800.

4.3.12 No FMS Position (Number 12)

1. Check PFD1 for GIA1/2 configuration, software or failed data path error
messages. Correct any errors before proceeding.
2. Make sure the airplane is located where its GPS antennas have a clear view of
the sky.
3. Check for possible external interference to the GPS receivers.
4. Ensure that a cell phone or a device using Wi-Fi/Bluetooth technology is not
turned on (even in a monitoring state) in the cabin.
5. Check the GPS strength bars on both GPS receivers on the GPS 1 or GPS 2
STATUS Display on the MFD. If the signal strength levels are erratic, disappear
and reappear rapidly, or switch between a solid and hollow bar frequently there is
an external device interfering with the GPS receivers. Turn off any devices that
radiate a signal in the local area or move the aircraft to another location to
remove the interference.
6. Make sure the airplane is not parked near a hanger with the doors open and
equipped with a GPS repeater.
7. Make sure the GIAs are online by checking for a green check mark on the MFD
System Status Page. If a GIA is not online (a red X will be present instead of a
green check mark), check for power input faults.
____________________________________________________________________________
LMM for the Kodiak 100
190-02102-00 Rev.4
Page 4-7