Gdu 1050 Display Unit Replacement - Garmin G1000 Line Maintenance Manual

Uncontrolled if Printed
______________________________________________________________________________

5.2.1 GDU 1050 Display Unit Replacement

Unit Part Number: 011-03470-10
Garmin Reference Documents:
• Captive Screw Hardware Replacement Instructions: 190-00313-65.
• SPIDER Installation Instructions: 190-00313-03.
• Shield Block Installation Instructions: 190-00313-09.
• Installation Manual: 190-00303-92.
The GDU 1050 is installed by holding the unit flush with the instrument panel. The
locking studs should be oriented with the alignment marks in the vertical position for
installation.
1. To Remove:
a) Using a 3/32" hex drive tool, turn all four 1/4-turn fasteners counterclockwise
until they reach their stops.
b) Carefully remove the display from the panel.
c) While supporting the display, disconnect the connector.
2. To Reinstall:
a) While supporting the display, attach the connector to the rear of the unit.
b) Carefully insert the display in the panel cutout, ensuring all four 1/4-turn
fasteners align with the corresponding holes.
c) Seat the display in the panel cutout. Do not use excessive force.
d) Once seated, turn all four 1/4-turn fasteners clockwise to lock the display to
the panel.
____________________________________________________________________________
Page 5-2 LMM for the Kodiak 100
190-02102-00 Rev.4