Garmin G1000 Line Maintenance Manual page 59

Uncontrolled if Printed
______________________________________________________________________________
box, then press the ENT key to uncheck the selection. Do this for all GMA 1347/
1360 files.
7. If a CARD COPY item is present, manually uncheck the configuration box by
using the small FMS knob to scroll down and highlight the configuration box, then
press the ENT key to uncheck the selection. This file was installed as part of the
baseline load. This is to save time in the load process. These instructions are
also used to install software for the first time. If this is done this way on the first
load, there wont be a copy.
8. Press the LOAD softkey.
9. Monitor the loading progress and make sure the software load completes without
errors as indicated by the following:
a) Green PASS or White N/A in all Configuration and Software columns.
b) Upload Complete. COMPLETE is in the summary box.
10. Press Delete if the Detected new LOG config window appears.
11. Press the ENT key to acknowledge the UPLOAD COMPLETE box.
12. Repeat steps 4 through 10 for each option file required. Use the large FMS knob
to move the cursor back to the ITEM window for Step 4.
13. After all option files are loaded, press the UPDT CFG softkey.
14. An "Update Configuration Module?" window appears. Press the ENT key to
select Yes.
15. After the update is complete, press the ENT key to select OK in the Update config
complete window.
____________________________________________________________________________
LMM for the Kodiak 100
190-02102-00 Rev.4
Figure 3-11. Update Confirmation
Page 3-9