Table of Contents
Advertisement
2-2
ELECTRICAL
These self-contained merchandisers have water-
cooled condensers. Each 4ft of case module has
a dedicated refrigeration system. For multi-
deck cases, the condensing unit may be located
behind interior back panels or on top of the
case.
These self-contained merchandisers are con-
trolled by the Corelink electronic control with
NOTES:
1. APPLICABLE STANDARDS / SPECIFICATIONS
ASME Y14.5M-1994, DIMENSIONS AND TOLERANCES
power relays located inside the sealed box.
2. KEY PRODUCT CHARACTERISTICS PER EPR-0006 & IDENTIFIED WITH SYMBOL
K
3. MATERIAL-
4. REF -
Hussmann recommends a gateway for defrost
coordination or setting the controller with the
correct time on the clock, cases with open ends
must have the same defrost times.
MERCHANDISER ELECTRICAL DATA
Refer to merchandiser serial plate or case data
sheets for electrical information.
P/N 3074287_H
Merchandiser must be grounded.
Do not remove the power supply cord ground.
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
ELECTRICAL CONNECTIONS
All wiring must be in compliance with NEC
and local codes. All electrical connections are
to be made in the controller enclosure.
FIELD WIRING
Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
R
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES.
THIRD
ANGLE
PROJECTION
P/N
REV
SHEET 3 OF 10
Risk of Electric Shock. If cord or plug
becomes damaged, replace only with
a cord and plug of the same type.
Advertisement
Table of Contents
