Table of Contents
Advertisement
5-6
6. Clean all surfaces including shelves and
honeycomb by spraying down water (prefera-
bly warm) and mild detergent. Use a brush or
cleaner pad if necessary to aid in penetrating
dirt.
7. Remove all the shelves and set aside then
remove the back panels.
8. Clean the backside of the back panels in the
case as you remove them.
9. Clean the newly exposed surfaces and the
coil by spraying down with water (preferably
warm) and a mild detergent solution.
10. Rinse the newly exposed surfaces and the
coil with water then spray with a sanitizer.
Allow surfaces to air-dry, since wiping would
defeat the purpose of sanitizing.
11. Replace the back panels and shelves.
12. Rinse all surfaces with water, then spray
with a sanitizer. Allow surfaces to air-dry since
wiping would defeat the purpose of sanitizing.
13. Replace all remaining internal parts care-
fully so that they seat properly. This is neces-
sary for proper case operation.
14. Turn ON power to the fans.
15. Replace product.
P/N 3074287_H
CLEANING HONEYCOMB ASSEMBLIES
Honeycombs should be cleaned every six
months, or depending on store environment
the honeycombs may need to be cleaned more
often. Dirty honeycombs will cause cases to
perform poorly.
The honeycombs may be cleaned with a
vacuum cleaner. Soap and water may be used if
all water is removed from the honeycomb cells
before replacing. Be careful not to damage the
honeycombs.
1. Remove honeycomb by pulling clip as
shown above.
2. Clean and dry the honeycomb.
3. Honeycomb is symmetrical.
4. After cleaning, replace honeycomb. Ensure
clip is centered and engaged along full-length
of honeycomb.
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
Deflector
Clip releases
Honeycomb
Damaged honeycomb must be replaced.
Slit at top
Honeycomb
Advertisement
Table of Contents
