Siemens PERFECT HARMONY GENIII/E Series User Manual page 50

The Keypad and Display Interface
The following illustrations depict the 2-line, 24-character display in various modes of access as the operator attempts
to locate and change the Ratio Control and Motor Frequency parameters.
Figure 3-12 depicts the display immediately, following power up or system reset. Note that the first three variable
displays (from the right) can be selected from a pick list using the Display Parameters (8000).
3
C A N C E L
S H IFT
E N T E R
Figure 3-12: Status Display After [SHIFT] [ENTER] ([CANCEL]) Key Sequence
The DEMD display (refer to Figure 3-12) shows the "commanded speed reference" in percent. Figure 3-13 depicts
the display following a [SHIFT]+[2] ([DRIVE]) key combination. From this point, the nine standard menus listed in
Table 3-6 can then be selected using the up/down arrow keys ([ ] and [ ]). Figure 3-14 depicts the display after the
down arrow key ([ ]) is pressed twice and prior to the selection of the Speed Setup Menu (2060). If the [ENTER] or
right arrow key ([ ]) is pressed at this display, the Speed Setup Menu (2060) will be entered. Figure 3-16 depicts the
display following a down arrow keystroke to the Ratio Control Parameter (2070). The down arrow key ([ ]) was
pressed once to obtain this display. Figure 3-17 depicts the display once the Ratio control parameter in the Speed
Setup Menu (2060) is entered for edit. Note the word "edit" appears in the display when a parameter is in the edit
mode. The left/right arrow keys ([ ] and [ ]) can be used to position the cursor under the desired digit (or sign) to
be changed. The digit can be set by either using the number keys, or it may be incremented/decremented using the up/
down arrow keys ([ ] and [ ]). The sign can be changed using the up/down arrow keys. The parameter is selected
into memory once the [ENTER] or right arrow key ([ ]) is pressed. Figure 3-18 depicts the display when a number
in range is entered.
Note: An asterisk (*) is used to denote when a parameter is changed from its current default value. This
allows the user to quickly see which parameters have been changed. To return a parameter to its factory
default value, press [SHIFT]+[ ] while in the edit mode.
3-14
M O D E D E M D F R E Q R P M IT O T
H A N D
Drive
DRIVE
SHIFT
(Arrow keys select)
2
Figure 3-13: Status Display After [SHIFT]+[2] Key Sequence
Speed setup
(2060)
Figure 3-14: Status Display After [ ] [ ] Key Sequence
Speed setup
(Arrow keys select)
Figure 3-15: Status Display After [ ]
s s s s
Perfect Harmony GENIII/e User's Manual
7 0 7 0 1 2 6 0
(2)
(submenu)
(2060)
A1A19000405A: Version 1.3
4 0