Table of Contents
Advertisement
Perfect Harmony GENIII/e User's Manual
Figure 3-17: Status Display After [ENTER] Key to Change a Parameter
Figure 3-18: Status Display Upon Entering a Value in the Range of the System
In the following example, a [SHIFT] [ ] is selected to get to the Parameter ID display. The parameter ID for Motor
Frequency (1020) is entered. See Figure 3-19. The [ENTER] key is then pressed once to show the Motor Frequency
display, and then [ENTER] is pressed again to edit its value. Figure 3-21 depicts the display if 010 is attempted to be
entered for the Motor Frequency. Since the range of the variable is 15 to 330, an error message will be displayed for
approximately 4 seconds, then the initial value, before the edit, is displayed.
SHIFT
Figure 3-19: Status Display After [SHIFT] [ ] and the Parameter ID 1020 is entered
CANCEL
ENTER
Figure 3-21: Status Display upon Entering a Value Beyond the Range of the System
A1A19000405A: Version 1.3
Ratio control
(2070)
Figure 3-16: Status Display After [ ] Key Sequence
Ratio control
CANCEL
ENTER
(edit)
Ratio control
*(edit)
Speed Parameter
Enter Param ID:
Motor Frequency
CANCEL
ENTER
(edit)
Figure 3-20: Status Display After [ENTER] [ENTER]
Motor Frequency
OUT OF RANGE
s s s s
The Keypad and Display Interface
1.0
± 001 .0
-03.0
1020
3
3-15
Advertisement
Table of Contents
