Siemens PERFECT HARMONY GENIII/E Series User Manual page 53

Perfect Harmony GENIII/e User's Manual
Table 3-5: Summary of Operation Mode Displays: Line 2 of Mode Display
Code Meaning
NOMV No medium voltage
INH CR3 inhibit
OFF Idle state
MAGN Magnetizing motor state
SPIN Spinning load state
UXFR Up transfer state
DXFR Down transfer state
KYPD Keypad speed demand
TEST Speed/Torque test
LOS Loss of Signal
AUTO Automatic mode
NET1 Network 1
NET2 Network 2
DECL Decelerating (no braking)
BRAK Dynamic Braking
COAS Coasting to stop
TUNE Auto-Tuning
HAND Hand mode
A1A19000405A: Version 1.3
Description
No input line voltage detected.
The CR3 or "Drive inhibit" input is asserted.
The drive is ready to run but is in an idle state.
The drive is magnetizing the motor.
The drive is trying to detect the speed of the motor to synchronize
the drive frequency.
The drive is in the "Up Transfer State" preparing to transfer the
motor to the input line.
The drive is in the "Down Transfer State" preparing to transfer the
motor from the input line to the drive.
The drive speed demand source is the keypad.
The drive is in a Speed or Torque test mode.
The drive 4-20mA analog input signal has dropped below a
predefined setting. See Tables 3-34, 3-35, 3-37, and 3-38.
The SOP flag AutoDisplayMode_O is set true usually to indicate
drive is receiving its speed demand from a source other than the
keypad or network. Typically used with a analog input speed
source.
Indicates drive is being controlled from Network 1.
Indicates drive is being controlled from Network 2.
The drive is decelerating normally.
Indicates that dynamic braking is enabled.
The drive is not controlling the motor and it is coasting to a stop
due only to friction.
The drive is in a "Auto-Tuning" mode used to determine motor
characteristics.
Appears if the drive is running under normal conditions.
s s s s
The Keypad and Display Interface
3
3-17