Installing A Compactflash Card; Removing And Installing Clock Modules - Cisco MDS 9500 Series Hardware Installation Manual

Removing and Installing Clock Modules

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Installing a CompactFlash Card

To install a CompactFlash card, follow these steps:
Step 1 Position the CompactFlash card with the connector end of the card toward the slot. The connector end
of the card is on the opposite side of the write-protection switch.
Insert the card into the slot until the card is firmly seated in the connector at the back of the slot and the
Step 2
ejector button pops out toward you.
Caution
Removing and Installing Clock Modules
The Cisco MDS 9500 Series includes one or more clock modules that are accessible from the back of
the chassis. In the unlikely event of a clock module failure, Cisco recommends that the failed clock
module be replaced during a maintenance window. The Cisco MDS 9513 and 9509 Directors have two
field-replacable clock modules. The Cisco MDS 9506 Director has one field-replacable clock module.
A separate procedure is provided for each type of director:
•
•
•
•
•
•
Before installing the clock module, check the contents of your kit.
clock module replacement kit, part number DS-C9513-CL.
Table 2-5
Quantity
1
1
These tools are required to remove or install a clock module:
•
•
Cisco MDS 9500 Series Hardware Installation Guide
2-76
The card does not insert all the way inside the slot; a portion of the card remains outside the
slot. Do not attempt to force the card past this point or you could damage the connector pins.
Removing a Clock Module from the Cisco MDS 9513 Director, page 2-77
Installing a Clock Module into the Cisco MDS 9513 Director, page 2-79
Removing a Clock Module from the Cisco MDS 9509 Director, page 2-80
Installing a Clock Module into the Cisco MDS 9509 Director, page 2-83
Removing a Clock Module from the Cisco MDS 9506 Director, page 2-83
Installing a Clock Module into the Cisco MDS 9506 Director, page 2-86
Contents of Cisco MDS 9513 Clock Module Replacement Kits
Part Description
Cisco MDS 9513 clock module
Disposable ESD wrist strap
Number 2 Phillips screwdriver
Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares
Chapter 2 Installing the Cisco MDS 9500 Series
Table 2-5 lists the contents of the
OL-19587-01