Cisco MDS 9500 Series Hardware Installation Manual page 121

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 2-22
1 Slot guides
2 EMI Gasket
Position the module in the chassis as follows:
Step 6
a.
OL-19587-01
Positioning a Module in the Chassis
1 2
3
4
4
5
6
6
3
4
Slide the module carefully into the slot until the EMI gasket along the top edge of the module
contacts the module in the slot above it and both ejector levers close to approximately 45 degrees
with respect to the front of the module (see
Removing, Installing, and Verifying Supervisor, Switching, and Services Modules
3 EMI Gasket
4 Ejector level (fully extended)
Figure 2-23).
Cisco MDS 9500 Series Hardware Installation Guide
2-41